Blueboard Insulation Panel Instructions

Blueboard insulation panels are easily cut with a sharp knife.

Undertile mat systems.

Concrete / Screeded Floors – Ensure floor surface is free of dust and debris prior to bonding boards in place with a good quality Rapid Set Flexible Floor tile adhesive, use a notched floor tiling comb to apply the adhesive to the floor and bed the insulation panels using a straight edge.

NOTE: Do not use solvent based or pre mixed adhesives as these tend to dry slowly.

For tiling either directly over Blueboard or to embed electric underfloor heating system use a Rapid Set Flexible Floor tile adhesive. Ensure that all heating mats and the cold tail electrical connection are fully embedded within the tile adhesive.

NOTE: Do not use solvent based or pre mixed adhesives.

A two part latex or fibre reinforced levelling compound may be applied to embed the heating system prior to tiling if desired and will make the job of tiling more straightforward.

ThermoLAM under laminate systems.

Blueboard insulation panels are easily cut with a sharp knife.

All sub floor types - Boards to be loose laid in a staggered brickwork fashion, boards can be taped together if required to prevent movement whilst laying out ThermoLAM foil heating mats.

To download these instructions as a pdf, click here

EU Cookie Law & GDPR Compliance

This site uses cookies to enable it to run more about how we use cookies.

To make this annoying pop up go away, please agree this usage is OK, or you can Opt Out

Check this box to agree that it is fine to enable cookies from Ambient Electical
And click I agree